grundig 43gfu7800b zae190r-2 emmc firmware

to see EMMC pinout photo as well as to download EMMC BIN Firmware. you must subscribe 👉Subscripetion, for Download

grundig 43GFU7800B

mainboard

MAINBOARD ZAE190R-2

emmc pinout

BOARD ZAE190R-2 crystal PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC

to see EMMC pinout photo as well as to download EMMC BIN Firmware. you must subscribe

pinout EMMC PROGRAMMER TNM 5000

READ EMMC PROGRAMMER TNM5000 PINOUT ZAE190R-2

READ EMMC

Programmer ISP Cable EMMC pin
ISP PIN 1 CMD
ISP PIN 3 RST-n(Reset) (mandatory)
ISP PIN 5 CLK (Clock)
ISP PIN 6 DAT0
ISP PIN 8,10 VSS (GND)
Vcc of Chip Must be ON. Reset is needed only when circuit reset is not working.

Note 1: After Selecting EMMC, programmer will be switched to Report view.
because EMMC files are too large and can’t be viewed by hex editor.
you can switch back to hex editor by unmarking the report button.

Note 2: Load & Save buttons has no use in EMMC nand. you must select filename
after pressing read or program buttons. File will be saved automatically with
Boot1, Boot2, RPMB, EXT_CSD extensions for different parts of the chip.

Note 3: After pressing read or Program, EMMC size and type will automatically
be Detected.

Note 4: Use Config Window for selecting Different Parts of the chip for read and write.
Also, chip Size and name is read from the chip and can be viewed in this window.

Note 5: Erase is for total chip erase. before Programming Each part, Programmer
will erase it automatically, so no need for chip erase before program.

Note 6: Only First 192 byte of EXT_CSD is writable by users and Some of these bytes
are read-only and some parts are one-time programable so if you write over these areas,
you get Write error.

Note 7: in most cases, Reset Pin is not necessory, Power on/off the device for reset

PINOUT EMMC RT809H

SCREEN 43T10-SOF XL BD

---

GRUNDIG MODEL 43GFU7800B

---

MAINBOARD ZAE190R-2

---

EMMC KLM8G1GETF-B041 Size: 7456MB

---

PANEL 43T10-SOF XL BD, T430QVN03.3B

---

READ EMMC PROGRAMMER TNM5000

---

---