MSD6A348-T8C2 EMMC THGBMFG6C1LBAIL Firmware DOWNLOAD

March 7, 2021
MSD6A348 T8C2 emmc Firmware
Share post with Friends

msd6a348-t8c2 emmc thgbmfg6c1lbail FIRMWARE download

BOARD MSD6A348 T8C2 ISP PROGRAMMER TNM5000

isp info programmer TNM5000 read emmc Firmware

ISP PIN READ EMMC TNM 5000

programmer TNM5000 EMMC

ISP CABLE EMMC PIN

ISP INFO READ EMMC PROGRAMMER TNM5000 READ EMMC BOARD MSD6A348-T8C2

Programmer ISP Cable EMMC pin
ISP PIN 1 CMD
ISP PIN 3 RST-n(Reset) (mandatory)
ISP PIN 5 CLK (Clock)
ISP PIN 6 DAT0
ISP PIN 8, 10 VSS (GND)
Vcc of Chip Must be ON. Reset is needed only when circuit reset is not working.

Note 1 : After Selecting EMMC, programmer will be switched to Report view.
because EMMC files are too large and can’t be viewed by hex editor.
you can switch back to hex editor by unmarking the report button
.

Note 2 : Load & Save buttons has no use in EMMC nand. you must select filename
after pressing read or program buttons. File will be saved automatically with
Boot 1, Boot 2, RPMB, EXT_CSD extensions for different parts of the chip.

Note 3 : After pressing read or Program, EMMC size and type will automatically
be Detected.

Note 4Use Config Window for selecting Different Parts of the chip for read and write.
Also, chip Size and name is read from the chip and can be viewed in this window.

Note 5 : Erase is for total chip erase. before Programming Each part, Programmer
will erase it automatically, so no need for chip erase before program.




Note 6 : Only First 192 byte of EXT_CSD is writable by users and Some of these bytes
are read-only and some parts are one-time programable so if you write over these areas,
you get Write error.

Note 7 : in most cases, Reset Pin is not necessory, Power on/off the device for reset


BOARD MSD6A348 T8C2 PROGRAMMER RT809H

BOARD MSD6A348-T8C2 PROGRAMMER RT809H

SPI PROGRAMMER RT809H READ EMMC BOARD MSD6A348-T8C2


model panel

MODEL PANEL K430WDC1

tv board t con board

BOARD TV T-CON BOARD

msd6a348-t8c2 emmc thgbmfg6c1lbail FIRMWARE download






repairalltv.com