FUEGO 65ELU610ANDT T.MT5522S.82 EMMC bin Firmware Download

June 14, 2021
FUEGO 65ELU610ANDT
Share post with Friends

fuego 65elu610andt t.mt5522s.82 emmc BIN firmware Download

POWER BOARD MAIN BOARD T CON BOARD

POWER BOARD MAIN BOARD T-CON BOARD

MAIN BOARD T.MT5522S.82

MAIN BOARD T.MT5522S.82

EMMC BIN FIRMWARE.

EMMC BIN FIRMWARE

emmc pinout

emmc pinout

T.MT5522S.82 crystal 24.000 MHz PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC

T.MT5522S.82 crystal 24.000 MHz PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC

READ EMMC PROGRAMMER TNM 5000

READ EMMC PROGRAMMER TNM 5000 BOARD T.MT5522S.82

ISP PIN READ EMMC TNM 5000

emmc pinout SPI PROGRAMMER TNM5000

ISP CABLE EMMC PIN

ISP INFO READ EMMC PROGRAMMER TNM5000 READ EMMC

Programmer ISP Cable EMMC pin
ISP PIN 1 CMD
ISP PIN 3 RST-n(Reset) (mandatory)
ISP PIN 5 CLK (Clock)
ISP PIN 6 DAT0
ISP PIN 8, 10 VSS (GND)
Vcc of Chip Must be ON. Reset is needed only when circuit reset is not working.

Note 1: After Selecting EMMC, programmer will be switched to Report view.
because EMMC files are too large and can’t be viewed by hex editor.
you can switch back to hex editor by unmarking the report button
.

Note 2: Load & Save buttons has no use in EMMC nand. you must select filename
after pressing read or program buttons. File will be saved automatically with
Boot 1, Boot 2, RPMB, EXT_CSD extensions for different parts of the chip.

Note 3: After pressing read or Program, EMMC size and type will automatically
be Detected

Note 4Use Config Window for selecting Different Parts of the chip for read and write.
Also, chip Size and name is read from the chip and can be viewed in this window.

Note 5: Erase is for total chip erase. before Programming Each part, Programmer
will erase it automatically, so no need for chip erase before program.




Note 6: Only First 192 byte of EXT_CSD is writable by users and Some of these bytes
are read-only and some parts are one-time programable so if you write over these areas,
you get Write error.

Note 7: in most cases, Reset Pin is not necessory, Power on/off the device for reset


T.MT5522S.82 crystal 24.000 MHz PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC 1

T.MT5522S.82 crystal 24.000 MHz PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC

RT809H EMMC READ

RT809H EMMC READ ISP INFO

CX650DLEDM

PANEL CX650DLEDM



repairalltv.com