SHARP 42CG3E TP.MS6486X.PB713 EMMC FIRMWARE

August 26, 2023

Share post with Friends

sharp 42cg3e tp.ms6486x.pb713 emmc firmware download

tp.ms6486x.pb713 emmc firmware

BOARD TP.MS6486X.PB713

KLM4G1FETE-B041 FIRMWARE

to see EMMC pinout photo as well as to download EMMC BIN Firmware. you must subscribe

TNM5000 ISP READ EMMC

EMMC ISP PROGRAMMER TNM5000

Programmer ISP Cable EMMC pin
ISP PIN 1 CMD
ISP PIN 3 RST-n(Reset) (mandatory)
ISP PIN 5 CLK (Clock)
ISP PIN 6 DAT0
ISP PIN 8,10 VSS (GND)

Vcc of Chip Must be ON. Reset is needed only when circuit reset is not working

Note 1: After Selecting EMMC, programmer will be switched to Report view.
because EMMC files are too large and can’t be viewed by hex editor.
you can switch back to hex editor by unmarking the report button.

Note 2: Load & Save buttons has no use in EMMC nand. you must select filename
after pressing read or program buttons. File will be saved automatically with
Boot1, Boot2, RPMB, EXT_CSD extensions for different parts of the chip.

Note 3: After pressing read or Program, EMMC size and type will automatically
be Detected.

Note 4: Use Config Window for selecting Different Parts of the chip for read and write.
Also, chip Size and name is read from the chip and can be viewed in this window.

Note 5: Erase is for total chip erase. before Programming Each part, Programmer
will erase it automatically, so no need for chip erase before program.

Note 6: Only First 192 byte of EXT_CSD is writable by users and Some of these bytes
are read-only and some parts are one-time programable so if you write over these areas,
you get Write error.

Note 7: in most cases, Reset Pin is not necessory, Power on/off the device for reset