VIVAX TV-40LE113T2S2SM CV6681H-A42 EMMC KLM8G1GETF-B041

May 1, 2021
TV 40LE113T2S2SM
Share post with Friends

vivax tv-40le113t2s2sm cv6681h-a42 emmc klm8g1getf-b041

BOARD TV 1

BOARD TV

BOARD CV6681H A42

BOARD CV6681H-A42

KLM8G1GETF B041 EMMC FIRMWARE

KLM8G1GETF-B041 EMMC FIRMWARE BOARD CV6681H-A42

BOARD EMMC

BOARD EMMC

PROGRAMMER TNM 5000 READ EMMC

PROGRAMMER TNM 5000 READ EMMC KLM8G1GETF-B041(ISP)

READ EMMC 220V

BOARD CV6681H-A42 crystal 24.000 MHz PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC

ISP PIN READ EMMC TNM 5000

TNM5000 ISP READ EMMC

ISP CABLE EMMC PIN

ISP INFO READ EMMC PROGRAMMER TNM5000 READ EMMC BOARD CV6681H-A42

Programmer ISP Cable EMMC pin
ISP PIN 1 CMD
ISP PIN 3 RST-n(Reset) (mandatory)
ISP PIN 5 CLK (Clock)
ISP PIN 6 DAT0
ISP PIN 8, 10 VSS (GND)
Vcc of Chip Must be ON. Reset is needed only when circuit reset is not working.

Note 1: After Selecting EMMC, programmer will be switched to Report view.
because EMMC files are too large and can’t be viewed by hex editor.
you can switch back to hex editor by unmarking the report button
.

Note 2: Load & Save buttons has no use in EMMC nand. you must select filename
after pressing read or program buttons. File will be saved automatically with
Boot 1, Boot 2, RPMB, EXT_CSD extensions for different parts of the chip.

Note 3: After pressing read or Program, EMMC size and type will automatically
be Detected

Note 4Use Config Window for selecting Different Parts of the chip for read and write.
Also, chip Size and name is read from the chip and can be viewed in this window.

Note 5: Erase is for total chip erase. before Programming Each part, Programmer
will erase it automatically, so no need for chip erase before program.




Note 6: Only First 192 byte of EXT_CSD is writable by users and Some of these bytes
are read-only and some parts are one-time programable so if you write over these areas,
you get Write error.

Note 7: in most cases, Reset Pin is not necessory, Power on/off the device for reset


PROGRAMMER READ EMMC RT809H

PROGRAMMER READ EMMC RT809H

READ EMMC 220V

CV6681H-A42 crystal 24.000 MHz PINS 1 and 2 connect with GND. tv must be in 220v plug. and read EMMC. no need for extra voltage. 3.3v and 1.8v. for reading EMMC

CX400DLEDM

MODEL PANEL CX400DLEDM

version 9

info☝ tv version image

.


repairalltv.com